Our Solution Benefits

GeoSpot is more energy efficient & environmentally Friendly than RealSpot Solution.

Our solutions uses Geothermal Borehole Thermal Energy Storage (BTES) scheme that is not only save energy but most importantly reduce greenhouse gas emissions. Using BTES system for both heating and cooling results in:

System Longevity

Years for the Mechanical Equipment

Years for the ground loop.

Improved Comfort & Indoor Air Quality

Our system targets the worker, not the workplace, which allows the system to decrease humidity levels and maintain temperature levels below design threshold limits to provide comfort to the workers. Also, Geothermal systems provide heating and cooling more evenly than conventional equipment resulting in a significant increase in comfort.

Flexible - Customized for each facility's specific needs

Below numbers are based on ,9500 square feet molding plant where client was going to use 90 tons of conventional system, actually ended up using only 16 tons of Spot Solution, huge cost savings.

Easy to install, economical to purchase

Our system is size to provide comfort to the worker rather than whole plant so the system size is much smaller as compare to conventional system which means lower Capital Cost and maintenance cost.

100% Capital Cost of Conventional system

50% Capital Cost with Our GeoSpot System

30% Cost with Our RealSpot System

Lower maintenance Cost

Geothermal systems have a longer life cycle: 25 years for the mechanical equipment and 50+ years for the (ground loop, compared to 15 to 20 year life expectancy for traditional HVAC equipment. With zero combustion and less moving parts, our GeoSpot system require less maintenance and cost when compare to RealSpot and Conventional system.

100% maintenance Cost of Conventional system

30% maintenance Cost with Our GeoSpot System

50% maintenance Cost with Our RealSpot System

Lower Operating Cost

Because 75% of geothermal energy is free, and GeoSpot system runs at maximum efficiency with coefficient of performance (COP) values from 4 to about 8, compared to COP values of around 3.5 for a conventional GSHP geothermal installation as the ground is set at substantially lower temperature around 35 degrees F with same system operating hours in cooling mode, the GeoSpot is extremely efficient and offer lower operating cost when compare to RealSpot and Conventional System.

100% Operating Cost of Conventional system

20% Operating Cost with Our GeoSpot System

35% Operating Cost with Our RealSpot System

Increased Safety

GeoSpot and RealSpot equipment are installed indoors. This improves longevity of equipment and provides a safe environment for maintenance staff. Workers are not exposed to the dangers of servicing equipment on rooftops. Also, there is no production of carbon monoxide from a geothermal system.

Environmentally Friendly

Reduce overall Green House Gas Emissions including zero on-site emissions. Geothermal heat pumps produce no GHG emissions on site. Due to the high efficiency and reduced use of electricity, geothermal heat pumps also produce less GHG emissions from offsite sources.

Also, GeoSpot and Real Spot use R410A refrigerants, which has an ozone depletion potential of zero. As well as helping to preserve the ozone layer, R410A boosts the operational efficiency of the air-conditioning system.

For RealSpot the heat may be provided with steam, hot water or electric heating. In certain circumstances the boiler system need to be added which use natural gas or propane as energy source. In Canada, natural gas is the main fuel used for municipal gas supply. Compared to oil and coal, this energy source generates lower levels of environmentally damaging substances such as NOx, SOx, and CO2.

Note:
1. The above graphics are based on IEA, “Natural Gas Prospects 2010,” 1986; The Institute of Applied Energy, “Report of the Corroborative Study of Assessment of the Impact of Thermal Power Plants on the Atmosphere,” March 1990.

2. The above comparisons use the emissions produced by coal as a baseline of 100.

Esthetics/Architectural Advantage

No outdoor condensing units or cooling towers on roof or ground provide architectural freedom and less structural concerns from weight of roof-top equipment.

Corporate Marketing

Generate message of your client's commitment to environmental responsibility through the use of sustainable and renewable energy. ABS Group experts can assist you with delivering that message with the local community.

Government Supports Geothermal Technology

Both the US and Canadian governments offer generous incentives to businesses that upgrade to: Geothermal Heating and Cooling systems in new builds and retrofits.